Jacuzzi Tub Guide

Please review the instructions below before you enjoy a relaxing soak in our Jacuzzi Tub.

Before filling the tub, ensure the drain is in the closed position.

Begin filling the tub from the faucet with water at your preferred temperature.

Press the “power” button to turn the display on. The display is not a touch-screen. Please use the directional pad, “enter” button, and “quick start” button to navigate.

You can use the “quick start” menu to turn on the Whirlpool or Air Bath and adjust their intensity or location.

Important! The Whirlpool jets SHOULD NOT be turned on until the water level has surpassed the jets on the side of the tub.

Turning the Whirlpool jets on too early will cause water to spray out of the tub. This could trigger the overflow sensor, disabling the water flow. 

The Air Bath, however, may be turned on at any time.

 

You can also utilize the Main Menu to further customize your experience: 

The “Experience” menu includes five different experiences that have been pre-loaded for your enjoyment. They include custom jet and lighting settings for any mood.

The tub heats the water as it flows through the jets, to maintain the water temperature. The main display will indicate the current temperature. If you wish to increase or decrease the water temperature, add more hot or cold water from the tap. 

 

Ready to get out?

To turn off the tub when you are finished, press and hold the “power” button for three seconds. 

Please drain the water by lifting the drain and turning it slightly to secure it in place. 

After the water has finished draining, the tub will activate the auto-dry feature.
The air jets will turn on and blow cool air for approximately two minutes. 

 

Questions or concerns?
Contact the Front Desk by dialing 0 from your room phone.